At Fri, 15 Jan 2021 17:04:19 +0800, "lchch1990@sina.cn" <lchch1990@sina.cn> wrote in
>
> >Mmm. Maybe something's missing. If you took the base-backup using
> >pg_basebackup, that means max_wal_senders > 0 on the primary. If you
> >lowered wal_level in the backup (or replica) then started it, You
> >would get something like this.
> >| FATAL: WAL streaming (max_wal_senders > 0) requires wal_level "replica" or "logical".
> >If you changed max_wal_senders to zero, you would get the following instead.
> >| FATAL: hot standby is not possible because max_wal_senders = 0 is a lower setting than on the primary server (its
valuewas 2)
> Then mark hot_standby off and continue try lowered wal_level.
> And do recovery from the basebackup, then you will see the FATAL.
>
> >So I couldn't reproduce the situation.
> >Anyways.
>
> >> My question is that what's the mean of [set wal_level to "replica" on the primary] in
> >> HINT describe, I can't think over a case to solve this FATAL by set wal_level, I can
> >> solve it by turn off hot_standby only.
> >>
> >> Do you think we can do this code change?
> >> --- a/src/backend/access/transam/xlog.c
> >> +++ b/src/backend/access/transam/xlog.c
> >> @@ -6300,7 +6300,7 @@ CheckRequiredParameterValues(void)
> >> if (ControlFile->wal_level < WAL_LEVEL_REPLICA)
> >> ereport(ERROR,
> >> (errmsg("hot standby is not possible because wal_level was not set to \"replica\" or higher on the primary
server"),
> >> - errhint("Either set wal_level to \"replica\" on the primary, or turn off hot_standby here.")));
> >> + errhint("You should turn off hot_standby here.")));
>
> >Since it's obvious that the change in a primary cannot be propagted by
> >taking a backup or starting replication, the first sentence reads to
> >me as "you should retake a base-backup from a primary where wal_level
> >is replica or higher". So *I* don't think it needs a fix.
> I think this HINT is want to guide users to finish this recovery, and the first guide is
> invalid in my opinion.
I think it's also important to suggest to the users how they can turn
on hot_standby on their standby. So, perhaps-a-bit-verbose hint would
be like this.
"Either start this standby from base backup taken after setting
wal_level to \"replica\" on the primary, or turn off hot_standby
here."
This this make sense?
regards.
--
Kyotaro Horiguchi
NTT Open Source Software Center