Re: Disk Benchmarking Question

Hi Dave,

 

Database disk performance has to take into account IOPs, and IMO, over MBPs, since it’s the ability of the disk subsystem to write lots of little bits (usually) versus writing giant globs, especially in direct attached storage (like yours, versus a SAN).  Most db disk benchmarks revolve around IOPs…and this is where SSDs utterly crush spinning disks.

 

You can get maybe 200 IOPs out of each disk, you have 4 in raid  10 so you get a whopping 400 IOPs.  A single quality SSD (like the Samsung 850 pro) will support a minimum of 40k IOPs on reads and 80k IOPs on writes.  That’s why SSDs are eliminating spinning disks when performance is critical and budget allows.

 

Back to your question – the MBPs is the capacity of interface, so it makes sense that it’s the same for both reads and writes.  The perc raid controller will be saving your bacon on writes, with 2gb cache (assuming it’s caching writes), so it becomes the equivalent of an SSD up to the capacity limit of the write cache.  With only 400 iops of write speed, with a busy server you can easily saturate the cache and then your system will drop to a crawl.

 

If I didn’t answer the intent of your question, feel free to clarify for me.

 

Mike

 

From: pgsql-performance-owner@postgresql.org [mailto:pgsql-performance-owner@postgresql.org] On Behalf Of Dave Stibrany
Sent: Thursday, March 17, 2016 1:45 PM
To: pgsql-performance@postgresql.org
Subject: [PERFORM] Disk Benchmarking Question

 

I'm pretty new to benchmarking hard disks and I'm looking for some advice on interpreting the results of some basic tests.

 

The server is:

- Dell PowerEdge R430

- 1 x Intel Xeon E5-2620 2.4GHz

- 32 GB RAM

- 4 x 600GB 10k SAS Seagate ST600MM0088 in RAID 10

- PERC H730P Raid Controller with 2GB cache in write back mode.

 

The OS is Ubuntu 14.04, I'm using LVM and I have an ext4 volume for /, and an xfs volume for PGDATA.

 

I ran some dd and bonnie++ tests and I'm a bit confused by the numbers. I ran 'bonnie++ -n0 -f' on the root volume.

 

Here's a link to the bonnie test results

https://www.dropbox.com/s/pwe2g5ht9fpjl2j/bonnie.today.html?dl=0

 

The vendor stats say sustained throughput of 215 to 108 MBps, so I guess I'd expect around 400-800 MBps read and 200-400 MBps write. In any case, I'm pretty confused as to why the read and write sequential speeds are almost identical. Does this look wrong?

 

Thanks,

 

Dave